Re: Computer reset?
[email protected] (MummyChunk) Sun, 14 Jan 2024 05:40:26 +0000
| Newsgroups | alt.autos.chrysler.sebring |
|---|---|
| Message-ID | <[email protected]> |
> Irv Finkleman wrote: > Once in a while my top won't go down, or if it's down, won't go > up. If I let the car sit for an hour or two it works ok again. This is > a very intermittent problem. Is there some form of reset/restart on the > computer, and if so, how is it activated? > > Any ideas would be appreciated. > > Thanks, > > Irv in Calgary One common cause of the convertible top not working properly is a worn out or faulty **latch motor** located above the windshield. This motor controls the sensors that detect the position of the top and the trunk. If the motor does not contact the sensors correctly, the top may stop halfway or the trunk may not close. You can try to lubricate the motor or replace it if necessary. Another possible cause is a **leak in the hydraulic system** that operates the top. This can result in a loss of fluid and pressure, which can affect the top's performance. You can check for leaks in the hoses or cylinders and refill the fluid if needed. The fluid reservoir is located under the rear seat cushion and can be accessed by removing the seat and the insulation. The fluid type is **Mopar 5127381AB Hydraulic Fluid**. There is no specific reset or restart procedure for the computer that controls the top, but you can try to **pull the fuses** for the top motor and reinstall them. This may clear any error codes or glitches in the system. The fuses are numbered **16 and 24** and are located in the fuse panel. This is a response to the post seen at: http://www.jlaforums.com/viewtopic.php?p=245554044#245554044