Editing ANSI screens.

Hola All!, saludo cordial

I know I might have asked this here a while back, buit looking at my historic 
messages for the life of me I cannot seem to find them.

I want to customize my BBS, meaning the ANSIs, prompts and menus but I found it 
a bit challenging, I was used to RA/ELEBBS way of showing columns so you knew 
exactly where something was going to be shown, so I have not been able to edit 
my prompts, I'm using pablodrazw and I've changed *some* screens but menus and 
prompts have proven to be difficult for me. I've read the docs that you can use 
Mystic's way to repeat characters and do cool stuff but I just couldn't figure 
it out.

for instace I tried editing  msghdr.asc using overwrite but when I tried 
reading a messaage the message header fields are gone, someone advised to sue 
the internal editor, I tried that but screwed up the prompts.

I know apart from this and some adive from reddit there's nt a lot more to seek 
for help.

Please try not to be rude if I miss any of your responses normally I read 
messages to me, so if you reply to somebody else on a response to me I might 
miss it but it's involuntary.

Many thanks. -- again--

--
Saludos/Kind Regards
David Gonzalez
- MikroTik Certified Trainer
- ESP.COLOMBIA, ESP.MIKROTIK Moderator
- SysOp @ SkyNet BBS | telnet://bbs.skynet.com:20023