Re: Seeburg "G" scanning issues?

On Saturday, September 5, 2020 at 11:32:25 PM UTC-5, Wayne B wrote:
> Hi all, 
> 
> It's been a while since I've posted here. I hope everyone is doing well and enjoying their Jukes more than ever during these times. 
> 
> After ignoring, and not playing my G for quite a while, I decided to tackle the issue that caused be to walk away from it for a bit. 
> 
> If the juke is playing, ll seems fine as long as there are selections selected, but upon initial start and often after the final selection plays and stops, if I make a selection, the record last played will be put back in the rack, the motor keeps spinning and the mech does not scan. If I then manually change the reversing switch direction to pick up a "B" side and flip the clutch latch lever, the carriage will scan and pick the next records. 
> 
> I'm sure there are no new problems that haven't been seen before, this seems like a strange one to me. 
> 
> Any suggestions? 
> 
> TIA 
> -Wayne
Just guessing, if the clutch wasn't cleaned properly, and that usually means removal to do, then that is where I'd start looking.