Re: press 4 to unlock core

bad sector <forgetski@postit_INVALID_.gov>
Newsgroups alt.comp.hardware
Message-ID <[email protected]>
On 2020-10-23 03:06, VanguardLH wrote:
> bad sector <forgetski@postit_INVALID_.gov> wrote:
> 
>> It's a Durgod Taurus k-320 (made in China), and the reason I got it
>> was that ...
>> ... I was up to here with num locks being ON by default so I wanted a
>> keyboard with NO numpad
> 
> Your BIOS might have settings for the default state of the keyboard on
> boot.  My BIOS (well, UEFI) has:
> 
>    Bootup Num-Lock
> 
>    Select whether Num Lock should be turned on or off when the system
>    boots up.
> 
> You should check if there is a similar setting in your BIOS.  I went to:
> 
> https://www.asus.com/us/Motherboards/CROSSHAIR_IV_FORMULA/
> 
> to see if an online copy of that mobo's manual was available, so I could
> see if it mentioned a NumLock setting in the BIOS.  Yep, that mobo's
> BIOS has a NumLock setting, so you could configure the keyboard to have
> its NumLock status either on or off on boot.
> 
>> As I said it's a problem ONLY in the very early stages of boot, and
>>
>> *I just realise now what that means*
>>
>> ..it's slow ONLY before the OS ignores the BIOS
>> and takes over, but then it's slow to the point of
>> sometimes being dead.
> 
> Got me confused.  It's slow before the OS loads ("before the OS ignores
> the BIOS") and it's slow when the OS loads ("then it's slow").  Up to
> when the POST screen shows, the BIOS is in charge.  It then locates the
> boot sector in the active-marked partition on the drive, loads the
> bootstrap code in that boot sector into memory, and passes control to
> that bootstrap code (for the OS).
> 
> So, up to when the POST screen appears (and when the BIOS is in charge),
> is the keyboard slow?  Or is it after the POST screen disappears (when
> the BIOS loads the OS' bootstrap code and passes control to it) when the
> gamer keyboard gets slow?
> 
> durgod.com does list a driver for that gamer keyboard.  Did you install
> it?  See https://www.durgod.com/Durgod-Zeus-Engine?_l=en.  The manual
> and software downloads are there.  Seems they use the same ones for all
> their keyboards.

I use Linux only but even with windows a driver
wouldn't do diddley before the OS loads.

> Since it is a USB device, there is handshaking between the OS and the
> device when the device sends its presentation data to the OS which
> identifies the device's type.  That presentation data gets stored in the
> registry under the Enumeration key.  If the enumeration data gets
> corrupted, the OS doesn't know what is the device type.  Cleaning out
> the enumeration data and forcing a new copy to get stored in the
> registry is easy for some but tricky to most.  I've had to do it when a
> USB device's enumeration data did not match on the USB device after its
> firmware got updated.  The enumeration data mismatch or corruption is
> why some techs' canned response is to move the USB device to a different
> USB port, but that won't delete the enumeration data for the original
> port should you plug the device back into the prior USB port.  No point
> in getting into erasing the old enumeration data and getting new
> presentation data stored in the registry if the keyboard is only slow
> BEFORE the OS loads (i.e., after the POST screen disappears).

But plugging it into another USB port DOES usually fix the
problem when for example a boot promt is waiting for a
response and I hav the time to do so. In contrast there isn't
time to do so to get to the BIOS because you don't find out
that 'Del' had no effect until it's too late. And this 'changing of
usb port' during BIOS (as a solution) is another aspect of the
thing that totally throws me....

> A USB-to-PS/2 adapter is of no use unless the keyboard itself support
> BOTH the USB and PS/2 hardware protocols.  They keyboard will
> automatically switch to match the hardware protocol of the port to which
> you connect the keyboard.  Make sure the next one actually says it
> supports *both* USB and PS/2.  The hardware protocol switch requires
> active logic, not just passive rewiring within an adapter.

Thanks, lesson learned
  
>>> cheap USB-only keyboard: no problem.
>>> gamer USB-only keyboard: problem exists.
>>>
>>> Problem resolved.  The gamer keyboard is farked.
>>    
>> Well, it _is_ a problem during early boot, the rest of the problem is
>> still waiting.
> 
> If slow up to the POST, and beyond into when the OS loads, then it
> sounds like the gamer keyboard is defective.  You can either suffer with
> it (type on a turd), return for warranty replacement (or return for
> refund if within the seller's refund policy period), or use something
> else that works reliably.  Your choice.

The return expired in August, a month after I bought it :(

> A search at amazon.com on "Durgod Taurus k-320" shows that keyboard can
> be bought for $100.  It's up to you if you want to invest another $20
> USD to ship it back for a warranty return or refund, and hope the
> problem isn't intrinsic to the design of that product which has you
> afflicted with the same problem with the warranty replacement.  That's
> why I'd first check if the seller will do a refund, and then get
> something else and cheaper.  I do like mechanical keyboards, and they
> are more expensive than the cheap rubber dome keyboards.  However, if I
> were to go to the expensive of a "gamer" mechanical keyboard, I'd get
> one that connects to PS/2.  That criteria excludes ALL of the Durgod
> keyboards.

Any specific suggestions (no numpad)?

> Personally I find the filtering at Amazon sucks, and why I rarely shop
> there unless I already know exactly what I want and can search on that
> string.  You can't use it to narrow the search to what you want.  "PC
> gaming keyboard" is NOT the same as getting to a keyboard category and
> then filtering by mechanical key.  Hell, you can't even filter by USB,
> USB-only, USB+PS/2, or PS/2.  Best you can do at Amazon is start from
> the top and use a search of "PS2 keyboard mechanical key <color>
> gaming", and in the search results pick the Brand filter to match on
> brands that I've heard of and perhaps have used before or based on
> reviews that I've read before purchasing.

I tend to agree
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.