Re: Can a weak CMOS battery prevent detection of a drive

>>>> I read that weak CMOS battery can prevent detection of a drive. I have
>>>> two
>>>> SSD drives. One an old Samsung 500GB boots reliably. Drive D: is a new
>>>> Seagate Barracuda, 500GB that is not detected reliably. I've done
>>>> everything
>>>> conceivable with the cables. I've read bad reviews on the Barracuda.
>>>>
>>>> BIOS program says CMOS battery is 3V whereas 3.3V might have been when 
>>>> it
>>>> was new.
>>>>
>>>> Is it worth my time to buy a new CMOS battery?
>>>>
>>>> Thanks
>>>>
>>>>
>>>
>>>
>>>
>>> Glad you got it figured out.
>>>
>>> To answer your question though, a 3.0 volt CMOS battery is fine.
>>>
>>> If the battery was too low, you'd simply lose your settings.
>>>
>>> I did *once* have a battery around 2.6 volts that would not allow the
>>> machine to post.
>>
>> Thanks for your reply.
>>
>> Unfortunately, no matter what fiddling I could do, the Seagate Barracuda
>> continued to show unreliable symptoms. Read/write errors and failure to
>> detect at boot up. I ran Seagate tools that said the drive was slow, at 
>> one
>> time. I read a bad review of Barracuda. We decided it's a bad drive. I 
>> have
>> a one year warranty. I bought a 3 TB WD HDD and installed it. I am now 
>> doing
>> a backup. Then I will return the drive for a replacement Barracuda SSD. 
>> High
>>
>> SSD drives are very nice for instantaneous response, when they work.
>>
>> I plan to run some large programs for medical imaging. When it comes to
>> medical diagnostic imaging, one needs to do it oneself.
>>
>>
>
>
>
> And you'll need a totally reliable drive for that.
>
>
> Speaking of medical imaging, when I was at my dentist....when they tried 
> to take an x-ray, their computer crashed. After a few attempts, I told 
> them to try a different USB port.
>
>
> All worked fine.
>
> I should have had them deduct my technical services from my bill.

More than that Philo,

Further back in this thread I thought I said I replaced the Seagate 
Barracuda with a good one. I also bought a 3TB WD HDD for backup. Prior to 
swapping out the bad Barracuda, I made a backup to the 3TB WD HDD. When I 
tried to restore, I ran into CPU overheating problems. Not every thermal 
grease is OK. Second try was "Kryonaut Ultra High Performance Thermal 
Grease" from thermal grizzly. Overheating problem was solved and restore is 
working.

The CPU I have may be heat damaged. I checked, the best CPU for this 
Gigabyte main board is Intel Q9650. I had an Intel Q9650 CPU but it burned 
out. Temperature reached 126C. then screen went blank. I ordered another 
Q9650 CPU from a reputable supplier. I'll start again.

Heat death of a CPU is slow. During slow death, Win10 is a bugger. If you 
see RunTimeBroker in Task Manager, you know you're in trouble. While it 
looks like a software problem it is more likely to be a cooling problem. I 
have a gaming case. I could install two more fans. I ordered 4 RAM heat 
spreaders. I'll do a before and after check with my IR Laser temperature 
gun.