Puxing Px 777 Programming Software 13

How to Program the Puxing PX-777 Radio with RT Systems Software
The Puxing PX-777 is a handheld radio that can operate on VHF or UHF frequencies. It has 128 memory channels, a backlit LCD display, a built-in FM radio, and a keypad for direct frequency entry. To program the radio with your desired frequencies and settings, you can use the RT Systems RPS-777 software and a USB-K4Y cable.

The RT Systems RPS-777 software is designed to make it easy and convenient to manage the memory channels and other menu options of the Puxing PX-777 radio from your PC. You can create and edit files with your preferred settings, and then transfer them to or from the radio. You can also access external data sources, such as repeater directories, to get the information you need for your location or travel destination.

Puxing Px 777 Programming Software 13
Download Zip https://itluperpe.blogspot.com/?file=2wGKcN



In this article, we will show you how to install the software and cable drivers, connect the radio to the PC, read and write data to the radio, and use some of the features of the software.

Installing the Software and Cable Drivers
Before you can program the radio, you need to install the RT Systems RPS-777 software and the drivers for the USB-K4Y cable. You can download the software from this link, and follow the instructions to install it on your PC. The software works with Windows 8/8.1 (full versions), Windows 10 (32 and 64 bit) and Windows 11.

The USB-K4Y cable is a special cable that connects the radio to the PC via a USB port. It has a 3.5 mm plug on one end that goes into the speaker/mic jack of the radio, and a USB connector on the other end that goes into the PC. You need to install the drivers for this cable before you can use it. The drivers are included in the software installation package, but you may need to manually allow them to run on your PC. You can find more details on how to install and troubleshoot the cable drivers here.

Connecting the Radio to the PC
Once you have installed the software and cable drivers, you can connect the radio to the PC using the USB-K4Y cable. Make sure that both devices are turned on, and that the volume knob of the radio is set to about halfway. Plug one end of the cable into the speaker/mic jack of the radio, and plug the other end into a USB port of your PC. You should see a message on your PC that says "Device is ready" or something similar.

Now you can launch the RT Systems RPS-777 software from your desktop or start menu. You should see a window like this:




This is where you can create and edit files with your desired settings for the radio. To sync your radio and PC, you need to read data from or write data to the radio.

Reading Data from the Radio
To read data from the radio, you need to select "Communications" from the menu bar, and then click on "Get data from radio". You should see a window like this:


This window shows you how to set up your radio for data transfer. You need to make sure that your radio is in VFO mode (not channel mode), that it is not scanning or transmitting, and that it has no CTCSS/DCS tones enabled. You also need to select the correct COM port for your cable (usually it is automatically detected by the software). Then click on
 35727fac0c