Turn off "inputmappedclassifier" default setting in weka explorer

Hi,

I am using weka explorer on a training set and a test set. I accidentally turned on the “inputmappedclassifier” default setting to always run when using an input test set. Could you please tell me how to turn this off so that when I run explorer using an inputed test set that it does not default to using the “inputmappedclassifier” when classifying? Thanks



Jason Smucny, Ph.D.
Assistant Professor
Imaging Research Center and Department of Psychiatry
University of California, Davis
[email protected]
**CONFIDENTIALITY NOTICE** This e-mail communication and any attachments are for the sole use of the intended recipient and may contain information that is confidential and privileged under state and federal privacy laws. If you received this e-mail in error, be aware that any unauthorized use, disclosure, copying, or distribution is strictly prohibited. If you received this e-mail in error, please contact the sender immediately and destroy/delete all copies of this message.

_______________________________________________
Wekalist mailing list -- [email protected]
Send posts to [email protected]
To unsubscribe send an email to [email protected]
To subscribe, unsubscribe, etc., visit https://list.waikato.ac.nz/postorius/lists/wekalist.list.waikato.ac.nz
List etiquette: http://www.cs.waikato.ac.nz/~ml/weka/mailinglist_etiquette.html