Re: how to get the temp file name

That does work, but it won't get me where I need to be.  The problem
is that the spoolfile isn't set after a parsing error - there is no
brigade in param->upload upon a bad parse.  I did find a simple way to
get a filter in there:

    apreq_hook_t * my_hook_handle = apreq_hook_make(req->pool,
my_hook, NULL, NULL);
    apreq_hook_add(aph, my_hook_handle);

I think I'll be able to set a note with this technique.

Brian McQueen

On 9/12/06, Issac Goldstand <[email protected]> wrote:
> Well, the spool file is just a normal apr_file_t, and the actual file
> handle is accessable via apreq_brigade_spoolfile(), so you'll likely
> want to do something like:
>
> (untested)
> char[255] filename;
> apr_status_t rv;
>
> rv = apr_file_name_get(&filename, apreq_brigade_spoolfile(param->upload));
>
>   Issac
>
> Brian McQueen wrote:
> > I am trying to figure out how to get the name of the temp file created
> > by apreq when it spools to the disk.  I have been through several
> > tries now and the most promising seems to be making a hook and adding
> > it to the parser.  The hook would get the name from the brigade as the
> > request is parsed, then it could put the name into a note which my
> > module could get later.  I'm struggling now to add my hook to the
> > parser.  I have a parser function, but not a parser_t at that stage of
> > my code - prior to reading and parsing - and the add_hook function
> > requires a parser_t.   At this stage the parser is not yet set.
> >
> > How can I directly add a hook to the parse_multipart parser?
> > Do any of you have any better ideas?
> >
> > Brian McQueen
>