RE: libapreq2 build to /usr/lib64
Morten Bjørnsvik <[email protected]>
| Newsgroups | gmane.comp.apache.mod-perl |
|---|---|
| Message-ID | <[email protected]> |
Hi I use the following when compiling libapreq: (the vaiables are just paths to the dirs and bins) Apache2::Request 2.13 libapreq2-2.13.tar.gz downloaded_201012171512 "$PERL_BIN Makefile.PL --with-apache2-apxs=$APXS_BIN --with-perl=$PERL_BIN --enable-lib64 --with-expat=$APACHE_DIR" -- MortenB -----Original Message----- From: James B. Muir [mailto:[email protected]] Sent: 28. april 2011 22:56 To: [email protected] Subject: RE: libapreq2 build to /usr/lib64 I followed this lead earlier to today but it did not lead anywhere in this case. Thanks for suggesting it. Fortunately I did find the solution. I added --libdir=/usr/lib64 to the ./configure: #!/bin/bash cd /usr/local/src/libapreq2-2.13 env LDFLAGS="-L/usr/lib64 -R/usr/lib64 -lexpat" ./configure --with-apache2-apxs= /usr/sbin/apxs --enable-perl-glue --with-perl=/usr/bin/perl --libdir="/usr/lib64" make && make test && make install -James