Re: user can still bruteforce HTTP authentication when his IP address is banned

Actually, the IP address was not blocked by the configuration I shared but
by modsecurity-crs.
If I disable modsecurity-crs config files in
/etc/apache2/mods-enabled/security2.conf and keep only modsecurity config
files, I can see that my configuration shared previously does not even
block IP addresses at all, do you know why?


On Tue, 28 Apr 2020 at 19:05, baptx <[email protected]> wrote:

> Hello,
>
> I would like to block a user IP address after several failed login
> attempts on an Apache web server using HTTP authentication (Basic or
> Digest).
> The configuration I am using should block an IP address after 3 errors
> (HTTP 401 Unauthorized response) but I can still try as many passwords as I
> want. If I try the correct password, I can see the HTTP 403 Forbidden error
> page. And if I press Ctrl+Shift+Del in Firefox to clear "Active Logins", I
> can continue the bruteforce again.
> It looks like ModSecurity is only blocking the page behind the login but
> not an actual bruteforce. Is it a ModSecurity bug or a problem with my
> configuration?
>
> I have added the following configuration in
> /etc/modsecurity/modsecurity_custom_rules.conf, based on the "IP-Based
> Blocking" example of
> https://snippets.aktagon.com/snippets/563-brute-force-authentication-protection-with-modsecurity
> (replace /testpage with a path using HTTP authentication):
>
> <LocationMatch /testpage>
>         # Uncomment to troubleshoot
>         #SecDebugLogLevel 9
>         #SecDebugLog /tmp/troubleshooting.log
>
>         # Enforce an existing IP address block
>         SecRule IP:bf_block "@eq 1" \
>                 "id:1,phase:2,deny,\
>                 msg:'IP address blocked because of suspected brute-force
> attack'"
>
>         # Check that this is a GET
>         SecRule REQUEST_METHOD "@streq GET"
> "id:2,phase:5,chain,t:none,nolog,pass"
>                 # AND Check for authentication failure and increment
> counters
>                 SecRule RESPONSE_STATUS "^401" \
>                         "setvar:IP.bf_counter=+1"
>
>         # Check for too many failures from a single IP address. Block for
> 10 minutes.
>         SecRule IP:bf_counter "@ge 3" \
>                 "id:3,phase:5,pass,t:none, \
>                 setvar:IP.bf_block,\
>                 setvar:!IP.bf_counter,\
>                 expirevar:IP.bf_block=600"
> </LocationMatch>
>
> Thanks.
>

_______________________________________________
mod-security-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mod-security-users
Commercial ModSecurity Rules and Support from Trustwave's SpiderLabs:
http://www.modsecurity.org/projects/commercial/rules/
http://www.modsecurity.org/projects/commercial/support/