Re: Trying out "early blocking"

Hi CM,

I was able to check that with the "regular" build options (that I
mentioned previously - Debian and Ubuntu feliver their packages
with those options.

Also I checked crs-setup.conf and enabled early blocking
mechanism:

https://github.com/coreruleset/coreruleset/blob/main/crs-setup.conf.example#L413-L421

I set up my config to use CRS on PL4 (to be sure that engine runs
as many rules as possible).

Then I sent a minimal but invalid request with telnet command:

telnet localhost 80
Trying ::1...
Connected to localhost.
Escape character is '^]'.
GET / HTTP/1.1
Host: 127.0.0.1

HTTP/1.1 200 OK
Date: Mon, 12 May 2025 08:32:07 GMT
Server: Apache/2.4.63 (Debian)
Content-Length: 0

Errors in this request:
* `Host` is an IP address - rule 920350
* `User-Agent` header is missing - rule 920320

These two rules collect 5 points which is enough to trigger rule
949111, which is responsible to deny the request in phase:1

https://github.com/coreruleset/coreruleset/blob/main/rules/REQUEST-949-BLOCKING-EVALUATION.conf#L212-L222

Here is the log:

ModSecurity: Warning. Operator EQ matched 1 at TX:early_blocking. [file "/home/airween/src/coreruleset/rules/REQUEST-949-BLOCKING-EVALUATION.conf"] [line "221"] [id "949111"] [msg "Inbound Anomaly Score Exceeded in phase 1 (Total Score: 5)"] [ver "OWASP_CRS/4.15.0-dev"]

(I get response 200 because the engine is in DetectionOnly mode,
and this is why you see "ModSecurity: Warning", and not "Access
Denied)

I think early blocking works as we expected.


Please check your config again - hope this summary helps you.


Regards,


a.




_______________________________________________
mod-security-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mod-security-users
Commercial ModSecurity Rules and Support from Trustwave's SpiderLabs:
http://www.modsecurity.org/projects/commercial/rules/
http://www.modsecurity.org/projects/commercial/support/