Re: wackamole convergence speed

There's no solution for that built into wackamole.  Previous attempts to 
alter the failure detection time have all been in the other direction, 
and have involved modifications to timeouts within the Spread toolkit.  
Modifications in the opposite direction shouldn't be impossible, and may 
suit your application here.  On the other hand, it would probably be 
easier to just add a delay that works similar to the balance timeout 
between the receipt of a regular membership message from Spread and the 
beginning of the GATHER state.

--Ryan Caudy

John Jolet wrote:

>I've got wackamole working great for ip failover.  Unfortunately, it's
>working TOO great.  apparently, we don't want the address to fail over any
>quicker than one minute.  apparently, we've got some networking issues that
>we hope to sweep under the rug by not failing over at the first sign of
>trouble.  is there a configuration parameter that will cause it to not fail
>the interface over unless it's been a minute?  
>
>_______________________________________________
>wackamole-users mailing list
>[email protected]
>http://lists.backhand.org/mailman/listinfo/wackamole-users
>
>  
>