Re: What does this error mean?

According to man amanda-changers the device properties can be specified in multiple places so where you have them should also work.

Anton "exuvo" Olsson
    [email protected]

On 2024-07-22 17:19, Robert Heller wrote:
>
> At Mon, 22 Jul 2024 17:10:23 +0200 Exuvo <[email protected]> wrote:
>
>> Never used S3 but dont you need to use a "tapdev" line and device properties on that instead of on the changer?
>> See man amanda-devices S3 Device
> No, that does not work.  Get a config file syntax error...   The docs are
> somewhat wrong.
>
>> Anton "exuvo" Olsson
>>      [email protected]
>>
>> On 2024-07-22 14:24, Robert Heller wrote:
>>> backup@sharky5:~$ amcheck sharky5
>>> Amanda Tape Server Host Check
>>> -----------------------------
>>> NOTE: tapelist file does not exists
>>>         it will be created on the next run
>>> NOTE: Holding disk '/var/lib/amanda/holdings/sharky5': 38816 MB disk space available, using 12000 MB as requested
>>> slot 1: While creating new S3 bucket: The request signature we calculated does not match the signature you provided. Check your key and signing method. (SignatureDoesNotMatch) (HTTP 403)
>>> slot 2: While creating new S3 bucket: The request signature we calculated does not match the signature you provided. Check your key and signing method. (SignatureDoesNotMatch) (HTTP 403)
>>>
>>> backup@sharky5:~$ cat /etc/amanda/sharky5/amanda.conf
>>> org "Deepwoods Software Sharky5"        # your organization name for reports
>>> mailto "[email protected]"    # space separated list of operators at your site
>>> dumpcycle 28 days       # the number of days in the normal dump cycle
>>> runspercycle 28          # the number of amdump runs in dumpcycle days
>>>                           # (1 week * 5 amdump runs per week -- just weekdays)
>>> tapecycle 40 tapes      # the number of tapes in rotation
>>>                           # 1 week (dumpcycle) times 5 tapes per week (just
>>>                           # the weekdays) plus a few to handle errors that
>>>                           # need amflush and so we do not overwrite the full
>>>                           # backups performed at the beginning of the previous
>>>                           # cycle
>>> runtapes 3              # number of tapes to be used in a single run of amdump
>>>
>>> define changer my_s3 {
>>>       tpchanger "chg-multi:s3:sharky5-backups/slot-{00..40}"
>>>       device-property "S3_ACCESS_KEY" "XXXXXXXXXXXXXXXXXXXXXX"
>>>       device-property "S3_SECRET_KEY" 'xxxxxxxxxxxxxxxxxxxxxxxxxx"
>>>       device-property "NB_THREADS_BACKUP" "3"
>>> #    changerfile "/etc/amanda/sharky5/changer.conf"
>>> }
>>> tpchanger "my_s3"
>>> tapetype S3     # what kind of tape it is (see tapetypes below)
>>>
>>>
>>> I am sure the S3_ACCESS_KEY and S3_SECRET_KEY are correct.
>>>
>>                                                                                    
>>