Re: restore from vtapes written by amvault
Bernhard Erdmann <[email protected]>
| Newsgroups | gmane.comp.archivers.amanda.user |
|---|---|
| Message-ID | <[email protected]> |
Hello,
Am 07.10.20 um 23:50 schrieb Nathan Stratton Treadway:
> Hmmm, the one thing that seems a little strange is the extra zeros at
> the end of the datetimestamp string on the DONE line....
you were well unterstood while first reading.
Original logfile:
$ grep "svr / " log.20201004123343.0
PART taper "ST:vtape" vBE-full-001 2 svr / 20000119 1/-1 0 [sec
43.408733 bytes 13631488 kps 306.666403]
DONE taper "ST:vtape" svr / 20000119000000 1 0 [sec 44.000000 bytes
13631488 kps 302.545455 orig-kb 0]
$ amadmin be-full find svr /
date host disk lv storage pool tape or file file part status
2000-01-19 svr / 0 be-full be-full BE-full-00 2 1/-1 OK
Modified logfile:
$ grep "svr / " log.20201004123343.0
PART taper "ST:vtape" vBE-full-001 2 svr / 20000119 1/-1 0 [sec
43.408733 bytes 13631488 kps 306.666403]
DONE taper "ST:vtape" svr / 20000119 1 0 [sec 44.000000 bytes 13631488
kps 302.545455 orig-kb 0]
$ amadmin be-full find svr /
date host disk lv storage pool tape or file file part status
2000-01-19 svr / 0 vtape vtape vBE-full-001 2 1/1 OK
2000-01-19 svr / 0 be-full be-full BE-full-00 2 1/-1 OK
But amfetchdump still does not know about tape vBE-full-001:
$ amfetchdump -d vtape be-full svr '^/$' 20000119
1 volume(s) needed for restoration
The following volumes are needed: BE-full-00
Press enter when ready
File 0 not found
Insert volume labeled 'BE-full-00' in vtape
and press enter, or ^D to abort.
File 0 not found
Insert volume labeled 'BE-full-00' in vtape
and press enter, or ^D to abort.
Aborted by user
$ amfetchdump be-full svr '^/$' 20000119
1 volume(s) needed for restoration
The following volumes are needed: BE-full-00
Press enter when ready
Source Volume 'BE-full-00' not found
Insert volume labeled 'BE-full-00' in
chg-multi:{/dev/nst0,/dev/nst1,/dev/nst2}
and press enter, or ^D to abort.
Aborted by user