Re: Amanda 3.5.1 - "ERROR: amcheck-device terminated with signal 11"
Nathan Stratton Treadway <[email protected]>
| Newsgroups | gmane.comp.archivers.amanda.user |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Oct 14, 2020 at 13:20:38 -0400, Chris Hoogendyk wrote: > I've been doing all the debugging stuff one one server. On my other > server, I had simply set it to traditional and it's been working. > Just now I went and applied ScanInventory.pm.patch_20201013C and > changed the amanda.conf back to using oldest. An amcheck daily told > me there were no acceptable volumes found! So I switched back to Hmmm... Well, clearly the exact failure mode different between the two servers :(. (You did previously see the "terminated with signal 11" error message on the eclogite server, right?) Did the dump that ran yesterday/last night actually write to the geo-daily-065 tape successfully, or was there some sort of changer error at run time? I guess the next thing to try would be to install ScanInventory.pm.patch_20201013B to enable some debugging, then run "amcheck -s" and "amtape ... taper" again and post the results. Those tests should be done using the oldest taperscan, but you can leave the amanda.conf as-is and test with -otaperscan on the command lines if you prefer. Also, since I assume the statefile has changed since you last posted it, I guess you should include it again (i.e. the version that is out then at the moemnt you are running those tests). Nathan ---------------------------------------------------------------------------- Nathan Stratton Treadway - [email protected] - Mid-Atlantic region Ray Ontko & Co. - Software consulting services - http://www.ontko.com/ GPG Key: http://www.ontko.com/~nathanst/gpg_key.txt ID: 1023D/ECFB6239 Key fingerprint = 6AD8 485E 20B9 5C71 231C 0C32 15F3 ADCD ECFB 6239