Re: Amrecover hangs after restore

Am 14.12.20 um 20:04 schrieb Gene Heskett:
> On Monday 14 December 2020 09:51:20 Stefan G. Weichinger wrote:
> 
>> Am 14.12.20 um 13:57 schrieb Gene Heskett:
>>> 1. take your Replyto: back out of your headers so I can reply to the
>>> list. To reply to the list I have to do a reply all, then swap the
>>> To: and CC: lines in kmail. Or just delete your .at address, so only
>>> the list gets a copy.
>>
>> Oh. Sorry. Better now?
> 
> Not until I added [email protected] to the mailing list manager for
> this folder in kmail.  Somewhat puzzling but now it seems to be working.
>   
>> Related to "identity" in Thunderbird etc

Sometimes TB gives me "reply to list", mostly not. I will see if I can 
set that up somehow.

>> The original topic of this thread was an issue happening at recovery
>> time. Your issue happens at dump time. What they might have in common
>> is using 2 or more tapes, so yes, maybe a similar underlying problem.

More precise: in my restore case it wasn't 2 *tapes*, but 2 separate 
dumps to restore from the same tape (a lev0 was flushed in the same run 
as the following lev1 was dumped).

I haven't yet done more tests on this, though. Should do.

>>> Take care Stefan, and stay well. Betsol is so far, all hat and no
>>> cattle, and this users list needs all the help it can get. I thank
>>> you for the suggestion, a lot.

Didn't know the "hat and cattle" saying (you know, english isn't my 
mother tongue), but I like that one ;-)

>> It was only a basic observation and hint, you're welcome.
> 
> I repeat, take care and stay well.

Thank you, same to you.