Re: Amanda Community release 3.5.2 - debian test packages

Am 16.09.22 um 17:52 schrieb gene heskett:

> The first thing I note is the use of port 5000, and I'm wondering about 
> the possibility of fighting
> over the ports as Octoprint uses FQDN:5000 as its web server to 
> administer its designated 3d printer.
> 
> I expect its changeable, and I've done it to Octoprint just for test, 
> works fine. But is that a potential
> problem if octoprint is sitting idle on a client at the time amanda gets 
> fired up? Something to check
> out I think, Stefan. Thanks.

Where do you see that port 5000?

I grep through the sources and I am not sure ...

my installation in a test VM seems to work so far, although not yet 
fully compatible to the Debian packages, as Jose mentioned