Re: Degraded dump in amanda 3.5.2

Hi Nathan, do you know if there is any setting to cause amanda to be 
more verbose?

Another weird thing is that the report says:

NOTES:
   planner: tapecycle (7) <= runspercycle (7)

However the config is like this:

tapecycle 8     # the number of tapes in rotation
runspercycle 7          # the number of amdump runs in dumpcycle days

the value reported for tapecycle is different than the one configured.

Pablo



El 7/1/2023 a las 15:24, Nathan Stratton Treadway escribió:
> On Fri, Dec 30, 2022 at 11:34:14 -0300, Pablo Venini wrote:
>> amcheck doesn't report errors
> Hmmm.
>
> As Stefan said, the key question is why Amanda is going into degraded
> mode.  Normally when I have that happen it's because the target tape
> wasn't available at the start of the amdump run, but that doesn't seem
> to be the situation in your case.
>
> But it seems like buried somewhere in your logs should be some futher
> explanation of why Amanda is switching to degraded mode (apparently
> mid-run)....
>
> 							Nathan
>
>
>
> ----------------------------------------------------------------------------
> Nathan Stratton Treadway  -  [email protected]  -  Mid-Atlantic region
> Ray Ontko & Co.  -  Software consulting services  -   http://www.ontko.com/
>   GPG Key: http://www.ontko.com/~nathanst/gpg_key.txt   ID: 1023D/ECFB6239
>   Key fingerprint = 6AD8 485E 20B9 5C71 231C  0C32 15F3 ADCD ECFB 6239