Re: Degraded dump in amanda 3.5.2

Yes, I was also thinking about installing 3.5.1; I installed 3.5.2 from 
RPM so I thought it was ok (I was reinstalling an old server wich ran 
3.3.9).

I tried your suggestion and if I run amdump for each DLE, the dumps are ok


El 18/1/2023 a las 06:23, Stefan G. Weichinger escribió:
> Am 18.01.23 um 01:47 schrieb Pablo Venini:
>> Hi Stefan, sorry for the delay in answering. This is a backup of the 
>> amanda server itself (configs, etc.), there is less than 100MB of 
>> information. What worries me is that if I use a holding disk without 
>> correcting the problem the dumps will go there instead of going to 
>> the vtapes.
>
> Did you also test this config with amanda-3.5.1? 3.5.2 is rather 
> untested, I think, as there are still no official packages available 
> afaik.
>
> I would define a small holding disk and see if that helps ... just for 
> debug purposes. A vtape-setup also benefits from a holding disk, no 
> reason to not use that with virtual tapes.
>
> What if you only dump specific DLEs?
>
> amdump myconf /etc
>
>
>
>
>