Re: Ardour3-3.1 does not build on FreeBSD i386 10.0

Paul Davis <[email protected]>
Newsgroups gmane.comp.audio.ardour.devel
Message-ID <CAFa_cKnxuncfM-4e_qS7XGjva+JY7_zL_nk1oO10VrZMP8y5eA@mail.gmail.com>
sorry, but wrappers around our wscript files are not something i'm going to
spend any time on at all.


On Thu, Jun 20, 2013 at 9:23 PM, outro pessoa <[email protected]>wrote:

> I'm sending the Makefile. It contains the C and CXX flags. Included are
> two files: opop.txt.bz2 and op22.txt.bz2. The former is before the C/CXX
> flags and the latter is after.
>
>
> On Thu, Jun 20, 2013 at 8:55 PM, Paul Davis <[email protected]>wrote:
>
>> this should already be fixed by the use of '-DBOOST_SYSTEM_NO_DEPRECATED'
>> for CFLAGS and CXXFLAGS.
>>
>>
>> On Thu, Jun 20, 2013 at 6:31 PM, outro pessoa <[email protected]>wrote:
>>
>>> I ran into a problem similar to this one:
>>> https://bugs.gentoo.org/show_bug.cgi?id=425578 with the same type of
>>> results.  Can this be approached from a configuration directory such as
>>> $PORTS_PATH/ardour-betaX or will it need to be done within the top level
>>> wscript file? I am aware that the old Scons build system was used and is
>>> referenced; but, I am looking for a solution similar to the problem I am
>>> encountering.
>>>
>>> Thanks and all for the help and advice so far.
>>>
>>>
>>> On Tue, Jun 18, 2013 at 7:38 PM, Paul Davis <[email protected]>wrote:
>>>
>>>>
>>>>
>>>>
>>>> On Tue, Jun 18, 2013 at 6:46 PM, outro pessoa <[email protected]>wrote:
>>>>
>>>>> I set clang, clang++, and clang-cpp with the full paths in the
>>>>> $PORT/Makefile.
>>>>> Another question...
>>>>> "$ ./ardev
>>>>> .: cannot open ./../build/gtk2_ardour/ardev_common_waf.sh: No such
>>>>> file or directory
>>>>> $ "
>>>>>
>>>>>
>>>>> http://pkgsubmit.mageia.org/autobuild/cauldron/x86_64/core/log/ardour3-3.0-0.13700.2.mga3.src.rpm/build.0.20130209132846.log
>>>>> had the exact same thing. The page is gone though.
>>>>>
>>>>> Does this require a link to a top level directory?
>>>>>
>>>>
>>>> no, it means that your build didn't work.
>>>> ../build/gtk2_ardour/ardev_common_waf.sh is a build target.
>>>>
>>>>
>>>
>>>
>>
>

_______________________________________________
ardour-dev mailing list
[email protected]
http://lists.ardour.org/listinfo.cgi/ardour-dev-ardour.org
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.