Re: Automation control point problem in A3

On 02/15/2014 08:09 AM, Thomas Vecchione wrote:
>
>
>
> On Sat, Feb 15, 2014 at 7:35 AM, Jörn Nettingsmeier 
> <[email protected] <mailto:[email protected]>> 
> wrote:
>
>
>     a problem with this is that you cannot easily create a point on an
>     existing line (to "save" the previous level up to this point).
>     what you have to do is click well outside of the existing
>     automation line for a new point to spring up, and then create
>     another point before that to restore the level up to that point.
>     if you want to be exact, that usually requires zooming out to the
>     previous point (which may be off-screen), hovering on it to read
>     the value, and re-setting the new point accordingly. cumbersome.
>
>
> But how often are you creating a single point on an existing line?

For the record, that's pretty much how I use it always. My gain lines 
are all manually designed, point by point. Proceeding two-points by 
two-points is a bit aggravating.

Best,

dp

_______________________________________________
ardour-dev mailing list
[email protected]
http://lists.ardour.org/listinfo.cgi/ardour-dev-ardour.org