Re: [Ardour-Cvs] Ardour source branch cairocanvas updated. 3.5-3238-gc2fc7f0

I can answer when you would want this.  When you are doing multiple splits
in a row.  It is very annoying on occasion to have to reselect the region
after splitting, and also on occasion causes issues as you end up clicking
at just the wrong time and it turns into a region drag as the view changes
to follow the playhead, etc. Since the playhead or edit point is only ever
at one point in time, the next operation should not happen on both of the
regions.


      Seablade

On Thu, Oct 2, 2014 at 4:01 PM, <[email protected]> wrote:

>
> - Log -----------------------------------------------------------------
> commit c2fc7f04a7854d99e8a040ebdf52a6330bd4fe8f
> Author: Colin Fletcher <[email protected]>
> Date:   Thu Oct 2 21:00:33 2014 +0100
>
>     Don't select newly created regions after splitting selected regions
> (except on Mixbus)
>
>     I can't see a reason to select the newly-created regions after
>     splitting selected regions: I can't think of any case where you'd want
>     the next operation to apply to both the regions, and it makes it very
>     easy (in my experience) to trim/move/&c. both regions afterwards by
>     mistake.
>
>     However, this behaviour is desired for Mixbus, so make the selection of
>     regions after a split of selected regions dependent on
>     Profile->get_mixbus() for now.
>

_______________________________________________
ardour-dev mailing list
[email protected]
http://lists.ardour.org/listinfo.cgi/ardour-dev-ardour.org