Re: External sync from another DAW: Ardour song pointer should follow ?
jonetsu <[email protected]>
| Newsgroups | gmane.comp.audio.ardour.user |
|---|---|
| Message-ID | <20180831185320.630a044a@mevla> |
On Fri, 31 Aug 2018 18:31:36 -0400 Paul Davis <[email protected]> wrote: > So you'll need to find out what Bitwig is doing (e.g. does it use JACK > transport by default? Does it think that it is always the time > master?) Bitwig is set to act as Jack transport sync master > Then you need to check whether you have Mixbus set to be the JACK time > master also. The only option I found related to this was in the session properties, namely "Mixbus32C is Jack Time Master ..." which is enabled. But still, MB will not restart at position 0 when Bitwig does. This said, it might be a Bitwig problem. > Finally, I'd suggest just recording in Mixbus and then exporting to > Bitwig, but that's your choice. Yes, that's what I was going to do, and probably what I will do. After all, if I can remember to manually set the track to 0 in MB before recording, the I could also use MIDI editing in MB of the performance. _______________________________________________ Ardour-Users mailing list [email protected] To unsubscribe or change your mailing preferences please visit: http://lists.ardour.org/listinfo.cgi/ardour-users-ardour.org