Re: Re: Problems with cdparanoia

Kim Lux wrote:
> 
> [krlux@h68-146-142-19 krlux]$ dmesg
> 000000000f0000 - 0000000000100000 (reserved)
>  BIOS-e820: 0000000000100000 - 0000000020000000 (usable)
>  BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)
>  BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved)
>  BIOS-e820: 00000000ffee0000 - 00000000fff00000 (reserved)
>  BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved)
> 512MB LOWMEM available.
> On node 0 totalpages: 131072
> zone(0): 4096 pages.

[ snip ]

> Uniform Multi-Platform E-IDE driver Revision: 6.31
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx
> SIS5513: IDE controller on PCI bus 00 dev 15
> SIS5513: chipset revision 208
> SIS5513: not 100% native mode: will probe irqs later
> SiS735
>     ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:DMA
>     ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:DMA
> hda: Maxtor 6Y060L0, ATA DISK drive
> hdd: CREATIVE CD2423E, ATAPI CD/DVD-ROM drive

You have a slave without a master.
That is wrong. Set the jumpers on your CDRW unit so SINGLE mode
( or if it has no such mode, then set it to MASTER mode ).


> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> blk: queue c02f0d64, I/O limit 4095Mb (mask 0xffffffff)
> hda: 120103200 sectors (61493 MB) w/2048KiB Cache, CHS=7476/255/63,
> UDMA(33)
> ide-floppy driver 0.99.newide
> Partition check:
>  hda: hda1 hda2 hda3
> Floppy drive(s): fd0 is 1.44M
> FDC 0 is a post-1991 82077
--- >8 ----
List archives:  http://www.xiph.org/archives/
Paranoia homepage: http://www.xiph.org/paranoia/
To unsubscribe from this list, send a message to '[email protected]'
containing only the word 'unsubscribe' in the body.  No subject is needed.
Unsubscribe messages sent to the list will be ignored/filtered.