Re: Re: Problems with cdparanoia

On Mon, 2 Dec 2002, David Balazic wrote:

> Kim Lux wrote:
> > Uniform Multi-Platform E-IDE driver Revision: 6.31
> > ide: Assuming 33MHz system bus speed for PIO modes; override with
> > idebus=xx
> > SIS5513: IDE controller on PCI bus 00 dev 15
> > SIS5513: chipset revision 208
> > SIS5513: not 100% native mode: will probe irqs later
> > SiS735
> >     ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:DMA
> >     ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:DMA
> > hda: Maxtor 6Y060L0, ATA DISK drive
> > hdd: CREATIVE CD2423E, ATAPI CD/DVD-ROM drive
> 
> You have a slave without a master.
> That is wrong. Set the jumpers on your CDRW unit so SINGLE mode
> ( or if it has no such mode, then set it to MASTER mode ).

I'm not sure if this is the problem, or even any problem. If I boot with
no removable drive in my swapable bay I wind up with a CD-RW as slave w/o
a master, and I don't recall any problem ever. I'm positive I use it to
read data CDs and burn CDs, I can't swear that I have done a rip (I do
very few) but it seems likely, since I only plug in a drive for testing or
full system backup.

Doing this on the first cable can confuse some BIOS versions, since they
feel a need to boot off of "C drive" every time, but I wouldn't expect a
problem with hdd and no hdc.

YMMV.

-- 
bill davidsen <[email protected]>
  CTO, TMR Associates, Inc
Doing interesting things with little computers since 1979.

--- >8 ----
List archives:  http://www.xiph.org/archives/
Paranoia homepage: http://www.xiph.org/paranoia/
To unsubscribe from this list, send a message to '[email protected]'
containing only the word 'unsubscribe' in the body.  No subject is needed.
Unsubscribe messages sent to the list will be ignored/filtered.