Re: SEMI-SOLVED many scsi timeout errors
Jack Pistachio <[email protected]>
| Newsgroups | gmane.comp.audio.cd-paranoia.general |
|---|---|
| Message-ID | <[email protected]> |
Well, after reading some of the archives, I decided to apply the same solution Ian did for the 686B Southbride. That is, I put the CDRW on the Promise controller. It worked... thanks to Ian for his posts. I thought that solution might apply only to older Via chipsets like the KT133, but Via's woes with CDROMs and Linux seems to continue. I'm not to happy about this, seeing as how a pretty penny was originally spent to get the best reviewed motherboard and chipset available at the time. It was a couple of months before I could solve this problem. Also, the Promise controller is not where I would like my CDRW to be. There it can only be used in PIO modes since the CDRW isn't a UDMA 100/133 drive, which are the DMA modes the controller supports. It also take away the space for my RAID array. There are other reasons too, but they are more minor. Now I suppose the question is: for anyone that has had success with the via chipset, what is your setup? Can you get a CDROM to rip on it? And when will there be more support for Via, especially in the kernel? Why, oh why do companies refuse to support the future of Linux when it is in their own good? BTW, for those interested more on my setup: Kernel 2.2.20 Debian Woody CDParanoia 9.8 - jackp --- Jack Pistachio <[email protected]> wrote: > I used to be able to rip cd's fine on my fairly new > system. > That was when I had two cdroms: a generic 40x as master > and HP CDWriter 8000+ as slave. I removed the generic > drive and gave it away. Since then when I try to rip cds > on the HP drive (which is the one I always used anyway > because it was more reliable), I get many scsi timeout > errors until the drive finally is reset. The kernel log > shows an interrupt error. I may have updated my kernel > since it was working but when I went back to the old > kernel > still didn't work. I can successfully rip cds with the > same drive and exact replica of the linux fs on an old > pentium. > > Relevant system components: > ga7vrxp mobo w/ > via kt333 8233a southbride > hp cdwriter connected to ide1 (hdc) > > I'm using scsi emulation but as I recall, ide-cd doesn't > work either. Anyone have any suggestions? Is this > purely > a kernel problem (i.e. via chipset problem)? > > - jackp __________________________________________________ Do you Yahoo!? Yahoo! Mail Plus - Powerful. Affordable. Sign up now. http://mailplus.yahoo.com --- >8 ---- List archives: http://www.xiph.org/archives/ Paranoia homepage: http://www.xiph.org/paranoia/ To unsubscribe from this list, send a message to '[email protected]' containing only the word 'unsubscribe' in the body. No subject is needed. Unsubscribe messages sent to the list will be ignored/filtered.