Re: SCSI CD Problems - a workaround solution
Lindsay Haisley <[email protected]>
| Newsgroups | gmane.comp.audio.cd-paranoia.general |
|---|---|
| Organization | FMP Computer Services |
| Message-ID | <[email protected]> |
Thus spake Jack Pistachio on Thu, Feb 13, 2003 at 10:52:35AM CST > Sounds like you didn't have the generic scsi device nodes > setup. Create these using mknod (major=21, minor=X where X > is sgX). > bash$ mknod sgX c 21 X > In your case, you need sg0 to use scd0. CDParanoia works > fine with scsi emulation, in fact it suggests it. scsi > emulation is also required for CD burning. The reason most > programs will work with the setup you had before is they > don't use the generic device, while CDParanoia makes quite > a bit of use with it. OK, thanks. I'll give this a shot. I really ought to be running devfs on the box, as I am on others I run, but have been too lazy/busy to set it up. Devfs would take care of this if I put the sg module in /etc/modules, and if it's really the issue then I'll probably take the time to set things up better. I solved the immediate problem by referencing the drive as an IDE rather than a SCSI device, so I could get my customer's work done, but if this turns out to be a proper fix then I'll use it. -- Lindsay Haisley | "Everything works | PGP public key FMP Computer Services | if you let it" | available at 512-259-1190 | (The Roadie) | <http://www.fmp.com/pubkeys> http://www.fmp.com | | --- >8 ---- List archives: http://www.xiph.org/archives/ Paranoia homepage: http://www.xiph.org/paranoia/ To unsubscribe from this list, send a message to '[email protected]' containing only the word 'unsubscribe' in the body. No subject is needed. Unsubscribe messages sent to the list will be ignored/filtered.