Re: lost interupt
Bill Davidsen <[email protected]>
| Newsgroups | gmane.comp.audio.cd-paranoia.general |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 4 Jun 2003, Sims, Ted wrote: > Again we must ask > Did VIA's price entice you? > Then purchase again... What has this to do with the question asked? He didn't mention VIA, and I have had no particular problems with VIA, SiS or Intel chipsets, all of which work on decent motherboards. And an incompetent vendor can mess up any chipset. Hopefully he has tried several CDs, enabling DMA on the reader, etc. I'd think config, reader, and kernel version before m/b hardware. > > > On Wed, 4 Jun 2003 21:36:19 +0200 > himbA <[email protected]> wrote: > > > Hello > > I'm trying to read audio Cd on my systwm. I have two CDroms, Teac both. One is > > attached as atapi drive on /dev/hdc (cdparanoia -vB -d /dev/cdrom) and > > another as scsi emulated drive on /dev/sr0 (cdparanoia -vB -d > > /dev/cdrecorder). when I try to rip track from any of drives i get, a lot of: > > > > kernel: hdc: lost interrupt > > > > in /var/log/messages (if using atapi drive) > > > > and for scsi emultated drive I also get some errors returnes by cdparanoia... > > > > SCSI transport error: timeout waiting to read packet > > > > scsi_read error: sector=13 length=13 retry=0 > > Sense key: 0 ASC: 0 ASCQ: 0 > > Transport error: Error reading command from device > > System error: Success > > > > > > Bottom line is, I don't get any tracks extracted, or should I say it takes > > about two hours to get 4 min. long track off the CD. CDrom light is always > > lit and progress bar updates read range very slowly... > > > > Playing Audio cds works fine... -- bill davidsen <[email protected]> CTO, TMR Associates, Inc Doing interesting things with little computers since 1979. --- >8 ---- List archives: http://www.xiph.org/archives/ Paranoia homepage: http://www.xiph.org/paranoia/ To unsubscribe from this list, send a message to '[email protected]' containing only the word 'unsubscribe' in the body. No subject is needed. Unsubscribe messages sent to the list will be ignored/filtered.