Re: cdparanoia stops predictably on certain disks

Try using scsi-emulation if you are using a 2.4.x series
kernel.  Make sure that the scsi emulation module pick up
the cd drive and that use have also compiled the sg module.

Also, there have been many timeout issues reported to the
list dealing with via southbridge chipsets.  If you have
one of these, another thing you could try is moving the
drive to the other controller (i.e. from the Via ide
controller to the Promise controller).  I would first try
using scsi emulation as cdparanoia is built with this in
mind.
- jackp


--- Ryan Reich <[email protected]> wrote:
> When ripping certain CDs, for now only any of three that
> came in the same set,
> but always at the same spot, cdparanoia stops and CPU
> activity goes to 0 and
> does not recover.  No messages appear in the logs until
> after I kill it, which
> takes a while to happen, when I get
> 
> ide-cd: cmd 0xbe timed out
> hdc: irq timeout: status=0xd0 { Busy }
> hdc: irq timeout: error=0x00
> hdc: ATAPI reset complete
> 
> in the kernel log.  The CD plays fine normally and does
> not appear scratched;
> certainly, cdparanoia does not detect anything wrong, but
> simply pauses and
> seems to wait for something.
> 
> Ryan Reich
> --- >8 ----
> List archives:  http://www.xiph.org/archives/
> Paranoia homepage: http://www.xiph.org/paranoia/
> To unsubscribe from this list, send a message to
> '[email protected]'
> containing only the word 'unsubscribe' in the body.  No
> subject is needed.
> Unsubscribe messages sent to the list will be
ignored/filtered.


__________________________________
Do you Yahoo!?
Yahoo! Finance: Get your refund fast by filing online.
http://taxes.yahoo.com/filing.html
--- >8 ----
List archives:  http://www.xiph.org/archives/
Paranoia homepage: http://www.xiph.org/paranoia/
To unsubscribe from this list, send a message to '[email protected]'
containing only the word 'unsubscribe' in the body.  No subject is needed.
Unsubscribe messages sent to the list will be ignored/filtered.