Re: is my drive defect - request for comments

Hi,

Joerg Schilling wrote:
> I will of course prefer to write in raw mode using cdrecord before
> writing in SAO mode with an unknown drive as I then know
> that many typical bugs in the CD writer firmware do not apply.

Any systematic problem with CD SAO would be restricted
to a very small set of drives. I use up a drive per
year and never got one that could not do SAO and TAO.
Yamaha, Lite-ON, LG, NEC, Samsung - all ok until they
did their due share of work and some day begin to
produce more and more failures.


> people in most cases solve their problems by writing in RAW mode
> or by killing hald.

If raw mode prevents hald from disturbing a
burn run then this is an undocumented feature.

It may be as well an urban legend like the
one behind padsize=300k and TAO.


> it is not possible to be sure as long as
> hald is runung.

Helmut Jarausch wrote:
> > the nearly broken medium was written after hald was stopped.

So no hald is involved here anyway.
Arresting the usual suspect did not help.


Known is that there was a failure with cdrecord,
a success with cdrecord -raw96r, and a success
with cdrskin (SAO). There also seem to be problems
with DVD. Helmut reports of a long idle time
before writing begins. (Exact media type unknown)

To Helmut: any new insight ?
Can you give us an overview of success and failure ?
(With media type and with commands that were used)


Have a nice day :)

Thomas


-- 
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]