Re: ide-scsi -> write_g1: scsi sendcmd: fatal error
"Thomas Schmitt" <[email protected]>
| Newsgroups | gmane.comp.audio.cd-record |
|---|---|
| Message-ID | <[email protected]> |
Hi,
> However, when "legacy /proc/scsi support" is enabled in a
> fresh kernel the performance and returned error remains the same.
That /proc/scsi stuff is for diagnostics. So no
remedy was to be expected. But what do you get now
from this ?
cat /proc/scsi/scsi
And from this ?
ls -d /sys/bus/scsi/devices/0:0:0:0/*:*
(it should tell the various addresses of
the burner: sg?, sr0, 0:0:0:0 )
Did cdrecord dev=/dev/sr0 show any other
behavior than dev=0,0,0 ?
You could try cdrskin instead of cdrecord.
Same arguments as with cdrecord (but no rscsi).
Possibly different error messages.
-------------------------------------------------
If this all does not bring insight, then you will
have to try living without using ide-scsi.
How about remote commands like:
cat dsl-1.1.iso | ssh ... 'cdrecord dev=ATA:0,1,0 -tao -'
cat dsl-1.1.iso | \
ssh ... 'cdrskin dev=ATA:0,1,0 -dao -isosize padsize=300k -'
(According to man cdrecord, -isosize cannot be
used with stdin. cdrskin allows this for the
first track. So one can use -dao or -sao.)
Is it sure at all that rscsi will not work
with "/dev/hdb" (concluded from "ATA:0,1,0")
rather than "0,0,0" (plus ide-scsi) ?
I see a discussion thread from last year:
http://lists.debian.org/cdwrite/2008/06/msg00026.html
How far did you get with that ?
Did it work finally ?
Have a nice day :)
Thomas
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]