Re: solaris cdrecord BH08LS20 drive BD-R problems

Rob W <[email protected]> wrote:

> > Do you still have problems with cdrecord on Solaris ?
> Thank you for asking Jörg. Today I made some progress.
> Sorry I have not had time to look at the USB driver bug.
>
> Previously I was using the JMicron JM20336 USB-SATA bridge.
> Now I have the JM20329, apparently a simpler (and slower) chip.
> The BH08LS20 drive connected via USB 2.0, using blank BD-R disc.
>
> Now I no longer get the I/O errors for cdrecord -atip (or -v -minfo).
> However, even though cdrecord -atip shows that the disc is blank,
> when I try to burn, cdrecord gives "capacity is unknown" message.
>
> Please advise me what to try next.
> Here is the output from the attempt to burn image to BD-R.
> Below that is the output from -v -checkdrive.
>
> # cdrecord -v dev=5,0,0 speed=2 driveropts=burnfree image.iso
> cdrecord: No write mode specified.
> cdrecord: Assuming -sao mode.
> cdrecord: If your drive does not accept -sao, try -tao.
> cdrecord: Future versions of cdrecord may have different drive dependent
> defaults.
> Cdrecord-ProDVD-ProBD-Clone 2.01.01a61 (sparc-sun-solaris2.10) Copyright (C)
> 1995-2009 J\366rg Schilling
> TOC Type: 1 = CD-ROM
> scsidev: '5,0,0'
> scsibus: 5 target: 0 lun: 0
> Warning: Using USCSI interface.
> Using libscg version 'schily-0.9'.
> Driveropts: 'burnfree'
> SCSI buffer size: 64512
> atapi: 0
> Device type    : Removable CD-ROM
> Version        : 0
> Response Format: 2
> Capabilities   :
> Vendor_info    : 'HL-DT-ST'
> Identifikation : 'BD-RE  BH08LS20 '
> Revision       : '1.00'
> Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
> Current: BD-R sequential recording
> Profile: BD-ROM
> Profile: BD-R sequential recording (current)
> Profile: BD-R random recording
> Profile: BD-RE
> Profile: DVD-RAM
> Profile: DVD-R sequential recording
> Profile: DVD-R/DL sequential recording
> Profile: DVD-R/DL layer jump recording
> Profile: DVD-RW sequential recording
> Profile: DVD-RW restricted overwrite
> Profile: DVD+RW
> Profile: DVD+R
> Profile: DVD+R/DL
> Profile: DVD-ROM
> Profile: CD-R
> Profile: CD-RW
> Profile: CD-ROM
> Profile: Removable Disk
> Using generic SCSI-3/mmc-3 BD-R driver (mmc_bdr).
> Driver flags   : NO-CD BD MMC-3 BURNFREE
> Supported modes: PACKET SAO LAYER_JUMP
> Drive buf size : 2097152 = 2048 KB
> Drive pbuf size: 3932160 = 3840 KB
> Drive DMA Speed: 3724 kB/s 21x CD 2x DVD 0x BD
> FIFO size      : 4194304 = 4096 KB
> Track 01: data  14911 MB
> Total size:     14911 MB = 7634764 sectors
> Current Secsize: 2048
> cdrecord: Disk capacity is unknown.
> cdrecord: Data will not fit on any CD.
> cdrecord: DVD/BD capacity is unknown.
> cdrecord: Cannot write more than remaining DVD/BD capacity.

Please send the output from cdrecord -minfo and cdrecord -atip.
It may be that your drive has similar firmware bugs for BD-* as we know 
for DVD-* and DVD+*

Jörg

-- 
 EMail:[email protected] (home) Jörg Schilling D-13353 Berlin
       [email protected]                (uni)  
       [email protected] (work) Blog: http://schily.blogspot.com/
 URL:  http://cdrecord.berlios.de/private/ ftp://ftp.berlios.de/pub/schily


-- 
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]