Re: AEC learning behaviour

This is not part of the current API.  It shouldn't be too hard add a
serialization routine for SpeexEchoState.

Stuart

On Thu, May 26, 2011 at 12:07 PM, Maris Engineering <[email protected]> wrote:
>> Yes, you are not forced to reset the AEC between calls at all, if you
>> can assume the actual echo path (physical environment) will not change
>> much, you can keep the instance and continue using it for the next call.
>>
>> Also what we did was keep the AEC running between calls - but we had a
>> rather high-duty system with sounds and signals played between calls, so
>> the AEC almost continuously had signal to stay adapted on.
>>
>
> This is the suboptimal approach...
>
>> 2011.05.25. 20:29 keltez?ssel, Stuart O. Anderson ?rta:
>>> Perhaps you could add a warm-start to the AEC, such that the parameters
>>> start near the correct values on all but the first use?
>
> ... and this is considered to be the optimum approach (for e.g. stationary
> units).
>
> It is this latter which I asked in this mailing list about, some time ago,
> without reasonable answer. Stuart, do you know if it's possible to
> retrieve the internal state variables in order to reassign them upon
> startint a new VoIP-connection?
>
> -Rob
> _______________________________________________
> Speex-dev mailing list
> [email protected]
> http://lists.xiph.org/mailman/listinfo/speex-dev
>
>