Re: Is it possible to change the quality with encoding ?

Hi Jozsef,

Thank you for your answer.

Yes I'm aware of that, I have implemented a control stream in order to change quality...


Le 9 oct. 2012 à 20:23, Jozsef Vass a écrit :

> Yes, you can change the quality while encoding. You can get all kinds
> of statistics from jitter buffer (number of packets stored, etc.) and
> can adjust the quality based on that. Please note that jitter buffer
> is on receiving side and adjusting the quality is on sender side, so
> you need to communicate your measurements to the other side.
> 
> Jozsef
> 
> On Mon, Oct 8, 2012 at 3:37 PM, Morgan <[email protected]> wrote:
>> Hi All,
>> 
>> Actually, the question is right on the topic.
>> 
>> Is it possible to change the quality while encoding ?
>> 
>> If the answer is yes, does the jitter buffer provides info about latency, e.g. : if latency is too high, we lower down the quality, if the latency is okay, we are raising the quality until latency rise up again...
>> 
>> Thank you for your help.
>> 
>> Morgan
>> 
>> 
>> 
>> _______________________________________________
>> Speex-dev mailing list
>> [email protected]
>> http://lists.xiph.org/mailman/listinfo/speex-dev