Re: channel manipulation
Joel Roth <[email protected]>
| Newsgroups | gmane.comp.audio.ecasound.general |
|---|---|
| Message-ID | <20120929182323.GA12028@sprite> |
On Sat, Sep 29, 2012 at 08:15:32PM +1000, Patrick Shirkey wrote: > > On Sat, September 29, 2012 7:56 pm, Joel Roth wrote: > >> > You may also find it easier (as I do) to write your commands to a file > >> > (e.g. Setup.ecs) and load it with > >> > > >> > ecasound -c -s Setup.ecs > >> > > >> > >> I already have a bash script so I'm running it like this: > >> > >> sh convert.sh > > > > If you do it as I recommend, you can use Ecasound's > > diagnostic commands (es, cs, fs) to check if your > > written setup matches what you actually want. > > > > Then you can use the 'start' command to run > > the audio engine. > > Can I load multiple chain setups and run them in parallel with this method? No. One Ecasound instance has one audio engine, which is configured by one chain setup at a time. You can switch between multiple named setups, but only use one at a time. Cheers, Joel -- Joel Roth ------------------------------------------------------------------------------ How fast is your code? 3 out of 4 devs don\\\'t know how their code performs in production. Find out how slow your code is with AppDynamics Lite. http://ad.doubleclick.net/clk;262219672;13503038;z? http://info.appdynamics.com/FreeJavaPerformanceDownload.html _______________________________________________ Ecasound-list mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ecasound-list