Autosampler and loop editing

I just picked up Autosampler and I'm digging it for the most part.  
This is a rescue mission for some sounds from my older and lesser  
gear. The incredible shrinking studio, etc.

The problem now is: I've never edited so many loops in EXS24. My  
clicking finger is begging for mercy. Are there any shortcuts which I  
don't know about (Logic Pro 8), such as enabling all loops across all  
samples/zones at once, setting the start/end/crossfade times to the  
same? I can fine tune the loops after they are set, but having a  
starting point for each would save a lot of time.

Thanks,
Glenn


________________________________________________________________________
EXS Users Group - new web forums! http://logic-users.org/forums/EXS
- To UNSUBSCRIBE: email [email protected]
- Search the entire archive: http://logic-users.org/forums/EXS/search 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/exs-users/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/exs-users/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/