Re: GPO mod wheel reset
Peter Ostry <po-r/[email protected]>
| Newsgroups | gmane.comp.audio.emagic.logic.off-topic |
|---|---|
| Message-ID | <[email protected]> |
On 16.06.2005, at 07:10, Jim Seaman wrote:
> At present I assign a GPO track with a CC#1 value of 127 at the
> beginning of the track and the track plays as it should but when I
> stop
> the sequencer the CC#1 goes to zero.
> When I restart the sequencer the CC#1 goes back to 127.
> This is good, however my problem is that when I have the sequencer
> stopped I cannot monitor anything I play on my keyboard controller
> assigned to that track because CC#1 (a.k.a.) volume is at zero.
Does the GPO use the ModWheel for volume? CC1 is usually the ModWheel
but you say the volume is down. Volume is usually CC7 (or CC11 if one
means Expression instead). I am a bit confused, there is no reset-
preset for volume and that would be a problem in many cases anyway.
___
Peter Ostry
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/logic-ot/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/