Re: Re: Monitoring with Saffire
Peter Ostry <po-r/[email protected]>
| Newsgroups | gmane.comp.audio.emagic.logic.off-topic |
|---|---|
| Message-ID | <[email protected]> |
On 12.01.2006, at 08:02, markdvc2002 wrote: > --- In [email protected], Peter Ostry <po@o...> wrote: >> does anyone of you have a Focusrite Saffire and uses extensive >> monitoring? >> >> I don't like the monitoring via that control panel which does not >> work properly anyway. I need two independend monitor mixes from > Logic >> panned and merged with 1-4 input signals and a full mix for the >> engineer. But I cannot get enough independend audio channels while >> recording, to monitor via a submixer. Only four. >> >> Are there some hints for flexible monitoring with a Saffire but >> without the control panel? > > Hi Peter > > I don't have a saffire, but do have a suggestion. Post this to the > LUG? It is certainly more on topic than some of the "intel mac" > discussions running right now ;-). I am interested in your suggestions, naturally. Just the Saffire game is over for me. I returned the first unit because of broken phantom power. The second unit worked a couple of hours until phantom power went down again. The dealer told me something about early series, repaired units and so on and the price was very low but I decided to stop that experiment, frighten the bank and go for a Fireface. I started with an Aggregate Device Saffire+Firewire 410 as the Saffire broke. That would make the system more flexible and give me 8 ins and 20 outs although I would keep the bigger latency of the 410. We can go to the LUG with that if you want, I just cannot test anything because the Saffire will leave the studio today. Would be more of a theoretically discussion. ___ Peter Ostry ________________________________________________________________________ Logic OT - new web forums! http://logic-users.org/forums/L-OT - Search the entire archive: http://logic-users.org/forums/L-OT/search - To UNSUBSCRIBE: email [email protected] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/logic-ot/ <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/