JL Cooper Synapse midi programmer

Message posted by Ron Dasaro <[email protected]>:

   I have a JL Cooper synapse 16 channel midi programmer & JL Cooper MSB +
Rev 2 8 channel midi programmer one of which I will be be integrating into
my Logic Pro 7 system. The JL Cooper pdf manual gives a few examples but is
not very clear on how to split & zone the keyboards, select two patches in
two registers,transpose, adjust velocity and then write all this information
to memory. After you have your routings configured at what point do you
write all of the information for it to be a working patch? I have all of my
routing for 12 selections in memory. Has there ever been a step by step
manual on how to do each of these commands, or any kind of tutorial for the
synapse? The MSB+ rev 2 I'm sure is similar
and at JL Cooper nobody knows anything about products unless they are new.
    Any help would be appreciated.

                                                           Prokey
                                                


________________________________________________________________________
Logic OT - new web forums! http://logic-users.org/forums/L-OT
- Search the entire archive: http://logic-users.org/forums/L-OT/search
- To UNSUBSCRIBE: email [email protected] 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-ot/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-ot/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/