Re: Logic 8 w Digidesign CoreAudio manager and a "HW in use" error

Ingo,

very very strange - I believe I checked everything well. From what I read in this forum (I 
am totally new here since today) there are a lot of different problems for different 
people... very discouraging to switch to ProTools hardware. But for film mixing stages 
there aren't 10 choices... 
So the assistant called and said that I should just swap the connectors of the Rosetta 800 
racks connected to the 2 HD cards and that would do the trick. It did. Without knowing 
why and what was wrong.
Thanks Ingo, very kind to reply so fast! I will read the posts here very carefully in the 
future! - And stick to my beloved Metric Halo interface for my "small" personal work and 
project preparation :-)

Best
Jurgen

--- In [email protected], "ingosand" <mail@...> wrote:
>
> Hi J�rgen,
> 
> Digi HW can only be used by either ProTools OR Core Audio.
> Check your system audio prefs.
> Don't use Digi as Core in or out.
> 
> Otherwise, just restart your engine and turn on your Interface before.



------------------------------------

________________________________________________________________________
Logic TDM Users Group - new forums! http://logic-users.org/forums/L-TDM
- To UNSUBSCRIBE: email [email protected]
- Search the entire archive: http://logic-users.org/forums/L-TDM/searchYahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-tdm/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-tdm/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/