Using HD192 in Native set up

Message posted by humuk <jack-afv5MR8Y+fFaa/[email protected]>:

We've been having problem after problem running our setup of Logic 8/G5
PPC/HD192 in a TDM system, and have been recommended to move away from TDM
to a Native set up using an Apogee interface.  Doing some research around
the net, someone has suggested using the HD192 as a generic interface
running in DTDM mode - can someone explain to me how this would work and how
to set it up?  Would we run all our audio on Coreaudio channels and route
them through the ESB bridge to output 1-2 of the HD192?  Would it be
possible to record in DAE and then mix Natively?  We've used our current TDM
set up for so long that we need a bit of a refresher in terms of how  Core
Audio/DTDM work before we start trying to make the switch from TDM.

Thanks

Jack

------------------------------------

________________________________________________________________________
Logic TDM Users Group - new forums! http://logic-users.org/forums/L-TDM
- To UNSUBSCRIBE: email [email protected]
- Search the entire archive: http://logic-users.org/forums/L-TDM/searchYahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-tdm/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-tdm/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/