LP9 Midi routing behavior strange

Dear all,

since I've upgraded to Logic Pro 9 my midi routing behaves strange.

My setup is a MacPro Quad Core with 8GB RAM on OSX 10.5.8 using 5 Unitor 8s. On Port 9 I've connected my Kyma and on port 5 my CM Labs Motormix that should control only the Kyma.

On the LP previous versions the display massages on the Motormix was reflecting the messages from Kyma correctly (these are send via Sysex to Motormix).

Now everything works apart from those sysex messages and I don't know why. Is there any kind of filter on LP9?

I've obviously checked that there weren't set any filter on a preference basis or project settings and none were ticked.

On the Project settings I've also ticked on the Midi Sysex Thru function in the Midi settings general tab... I was just able to get one brief message sent from Kyma to the MM and that was it. All the faders and buttons work correctly.

 When I connect the MM to the Kymna directly all messages are there.

Unfortunately MM has no Midi Thru box so that I can't use the direct connection in the setup and to be honest I rather don't buy a little thru box, because it used to work.

Any help would be very much appreciated

Best regards,

Sven



------------------------------------

________________________________________________________________________
Logic TDM Users Group - new forums! http://logic-users.org/forums/L-TDM
- To UNSUBSCRIBE: email [email protected]
- Search the entire archive: http://logic-users.org/forums/L-TDM/searchYahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-tdm/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-tdm/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/