Merge with selected regions and Merge only in cycle record.

Hello,

qrt has just posted in the Logic 9 forum of Logic Users Group under the title of Merge with selected regions and Merge only in cycle record.

This thread is located at http://www.logic-users-group.com/forums/showthread.php?t=4193

Here is the message that has just been posted:
***************
Hi

I was checking out the 'Merge with selected regions' and Merge only in cycle record' features from the Settings > Record (midi section). 

Do they do the same thing?  

If I choose 'Merge with selected regions' and set a cycle of say 1 or 2 bars and press record, record some chords, then once its gone round, record say a melody.

I did the the same thing with 'Merge only in cycle record' and got the same result.

I also noticed that if I chose 'Merge only in cycle record' and record 2 bars without the cycle on, then press stop and press record again, whatever I play over those two bars is merged with what I played before, even though I haven't activated cycle mode?

Has anybody found this?
***************


------------------------------------

The LUG has a new home on the web,  to visit and sign up please go to:

http://www.logic-users-group.com/











Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/logic-users/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/logic-users/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/