Re: Recording project playback to audio file

   I finally did this for the first time today.  It was interesting.

   My approach was to run jack-record and just give it a wav filename.

$ jack-record test.wav

   After that, jack-record appears in the qjackctl graph and I can 
connect the output of rosegarden and the output of fluidsynth to it. 
This then records whatever I am doing.  Play the song in rg.  Ctrl-C 
jack-record when done.  Pull the wav file into Audacity and clean it up. 
  Save.  Done.

   Sounds similar to what you are trying to do.  Anyway, since I'm a 
little more familiar with the mixdown process, I might be able to help 
if you still have problems related to this.  I can at least test things 
now that I understand this better.

Ted.

On 7/10/21 8:46 PM, [email protected] wrote:
> 
> RG-20.12/Qsynth/Qjackctl/Suse Leap-15.3
> 
> I'm forced to use jack_capture again
> (which in turn sometimes works sometimes
> doesn't). With qjackctl the last time I
> ran into this it was necessary to include
> the following jack connections which were
> not automatically established:
> 
> Readable       Writable
> Qsynth       RG
> L-00 ----  rec in 1L
> R-00 ----  rec in 1R
> 
> RG                  System
> master out L   ---- PlyBck 1
> master out R   ---- PlyBck 2
> Rec moni out L ---- PlyBck 1
> Rec moni out R ---- PlyBck 2
> 
> Now with this same setup going through
> the hoops just records an empty file.
> Probably not a factor but the last used
> path for recording is stored BUT causes
> an alert 'inaccessible or not writable'.
> Just clickick the fix-now button and
> OK-ing the path kills the alert. The audio
> file does get saved ..but it's empty.
> 
>    
> 
> 
> _______________________________________________
> Rosegarden-user mailing list
> Rosegarden-user-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org - use the link below to unsubscribe
> https://lists.sourceforge.net/lists/listinfo/rosegarden-user