Re: pipe to snd-aloop
Måns Rullgård <[email protected]>
| Newsgroups | gmane.comp.audio.sox |
|---|---|
| Message-ID | <[email protected]> |
Chris Percol <[email protected]> writes: > Hi, > > I'm trying to pipe audio output on my raspberry pi3 to a snd-aloop device > (hw:0,0,0). > > I have had no success so far and was hoping someone could point out how I > could update the following command to send the output to my loop device? > > rtl_fm -f 132.076M -M usb -r 24k -l 0 -p 55 -E deemp -g 20 | play -r 24k -t > raw -e s -b 16 -c 1 -V1 - > > I experimented with setting AUDIODEV=hw:0,0,0 but the command still seems > to output to the pi's default audio device. Replace "play ..." with "sox ... -t alsa hw:0,0,0" -- Måns Rullgård ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot