Re: sox/mansr: DSD to PCM

[email protected] writes:

> My question: Because we use this conversion to convert music files, which
> are basically of the very best quality, in a way that goes very far
> (conversion with influence of noise, time, gain and more ...), a
> discussion with a 360 degree view of all phenomena would be very helpful,
> how this can best be done with Sox to get an adequate (here) PCM file. The
> standard procedure with Xrecode3, for example, is not optimal.

The 'rate' effect with no special options should give good results.
Conversion of DSD64 to a rate higher than 48 kHz will end up with some
ultrasonic noise.  If you don't like this, you can reduce it with an
additional low-pass filter.  That's all there is to it.

-- 
Måns Rullgård