Re: [PATCH v3 2/7] binman: Fix FIT image overlap issues
Simon Glass <[email protected]>
| Newsgroups | gmane.comp.boot-loaders.u-boot |
|---|---|
| Message-ID | <CAFLszTiLg4VUv7Bm1aGWFq921MyqOZR1rJww2dykvCO6qOZGpg@mail.gmail.com> |
On 2026-07-21T15:21:05, Aristo Chen <[email protected]> wrote: > binman: Fix FIT image overlap issues > > Several binman test fixtures describe FIT images whose configuration > references both a u-boot firmware image loaded at address 0x0 with a > size of 0x2e bytes and a split-elf atf image whose first segment is > loaded at 0x10, so the two images overlap in memory. The upcoming > mkimage load address overlap check refuses to build such images, > which makes the tests that run these fixtures through mkimage fail. > > Move the u-boot load and entry addresses to 0x2000, clear of the atf > segments taken from elf_sections.lds, in the fixtures used by > testFitFirmwareLoadables, testFitSignSimple, > testFitSignNoSignatureNodes, testFitSignEngineSimple, > testFitSignEncryptEngine, testFitSignPKCS11Simple, > testFitSignPKCS11Object, testFitSignMultipleKeyPaths and > testKeyNameHintIsPathSimpleFit. > > Signed-off-by: Aristo Chen <[email protected]> > > tools/binman/test/fit/firmware_loadables.dts | 4 ++-- > tools/binman/test/fit/key_name_hint_dir_signature.dts | 4 ++-- > tools/binman/test/fit/signature.dts | 4 ++-- > tools/binman/test/fit/signature_engine.dts | 4 ++-- > tools/binman/test/fit/signature_engine_encrypt.dts | 4 ++-- > tools/binman/test/fit/signature_engine_pkcs11.dts | 4 ++-- > tools/binman/test/fit/signature_engine_pkcs11_object.dts | 4 ++-- > tools/binman/test/fit/signature_multi_key.dts | 4 ++-- > tools/binman/test/fit/signature_no_nodes.dts | 4 ++-- > 9 files changed, 18 insertions(+), 18 deletions(-) Reviewed-by: Simon Glass <[email protected]>