[PATCH v3 06/12] rockchip: doc: add more eMMC program examples
Johan Jonker <[email protected]>
| Newsgroups | gmane.comp.boot-loaders.u-boot |
|---|---|
| Message-ID | <[email protected]> |
There are more tools that can program a eMMC. Add more eMMC program examples. Signed-off-by: Johan Jonker <[email protected]> --- Changed V3: use eMMC use list per example mention loader matching to SoC --- doc/board/rockchip/rockchip.rst | 47 +++++++++++++++++++++------------ 1 file changed, 30 insertions(+), 17 deletions(-) diff --git a/doc/board/rockchip/rockchip.rst b/doc/board/rockchip/rockchip.rst index af5c00591234..c089419b65e5 100644 --- a/doc/board/rockchip/rockchip.rst +++ b/doc/board/rockchip/rockchip.rst @@ -393,36 +393,49 @@ To write an image that boots from a SD card (assumed to be /dev/sda): eMMC """" -eMMC flash would probe on mmc0 in most of the Rockchip platforms. +* Program example with fastboot for rk3399 and full U-Boot: -Create GPT partition layout as defined in $partitions: + eMMC flash would probe on mmc0 in most of the Rockchip platforms. -.. code-block:: bash + Create GPT partition layout as defined in $partitions: - mmc dev 0 - gpt write mmc 0 $partitions + .. code-block:: bash -Connect the USB-OTG cable between the host and a target device. + mmc dev 0 + gpt write mmc 0 $partitions -Launch fastboot on the target with: + Connect the USB-OTG cable between the host and a target device. -.. code-block:: bash + Launch fastboot on the target with: - fastboot 0 + .. code-block:: bash -Upon a successful gadget connection the host shows the USB device with: + fastboot 0 -.. code-block:: bash + Upon a successful gadget connection the host shows the USB device with: - lsusb - # Bus 001 Device 020: ID 2207:330c Fuzhou Rockchip Electronics Company RK3399 in Mask ROM mode + .. code-block:: bash -Program the flash with: + lsusb + # Bus 001 Device 020: ID 2207:330c Fuzhou Rockchip Electronics Company RK3399 in Mask ROM mode -.. code-block:: bash + Program the flash with: + + .. code-block:: bash + + sudo fastboot -i 0x2207 flash loader1 idbloader.img + sudo fastboot -i 0x2207 flash loader2 u-boot.itb + +* Program example with rkdeveloptool for rk3308 in BootROM mode: + + Use a loader binary that matches the SoC. + + .. code-block:: bash - sudo fastboot -i 0x2207 flash loader1 idbloader.img - sudo fastboot -i 0x2207 flash loader2 u-boot.itb + rkdeveloptool db rk3308_loader_v1.26.117.bin + rkdeveloptool wl 0x40 idbloader.img + rkdeveloptool wl 0x4000 u-boot.itb + rkdeveloptool rd Note: -- 2.39.5