[PATCH v8 04/11] pinctrl: k1: add IO power domain configuration support

Dual-voltage GPIO banks default to 3.3V, but when externally supplied
with 1.8V the internal logic must be explicitly reconfigured to match.

Add the ability to program IO power domain control registers through the
APBC block. These registers require unlocking the AIB Secure Access
Register (ASAR) before every read/write, since configuring a 1.8V domain
while 3.3V is externally supplied can cause back-powering and pin damage.

Signed-off-by: Eric Chung <[email protected]>
Reviewed-by: Yao Zi <[email protected]>

---
v7:
- Remove the dependency on SYSCON.
v6:
- Use dev_read_phandle_with_args() to fetch "spacemit,apbc" instead.
v5:
- Use tabs for macro definition alignment.
- Fix the missing power source argument.
v3:
- Add SYSCON dependency in Kconfig.
- Fix not sorted issue in the driver.
---
 drivers/pinctrl/spacemit/pinctrl-k1.c | 95 +++++++++++++++++++++++++++++++++--
 1 file changed, 92 insertions(+), 3 deletions(-)

diff --git a/drivers/pinctrl/spacemit/pinctrl-k1.c b/drivers/pinctrl/spacemit/pinctrl-k1.c
index 4e65fad1e8c5..9c0fa4badc25 100644
--- a/drivers/pinctrl/spacemit/pinctrl-k1.c
+++ b/drivers/pinctrl/spacemit/pinctrl-k1.c
@@ -13,6 +13,7 @@
 #include <linux/bitops.h>
 #include <linux/errno.h>
 #include <linux/io.h>
+#include <regmap.h>
 
 /*
  * +---------+----------+-----------+--------+--------+----------+--------+
@@ -35,8 +36,23 @@
 #define PAD_PULLUP		BIT(14)
 #define PAD_PULL_EN		BIT(15)
 
-#define PIN_POWER_STATE_1V8		1800
-#define PIN_POWER_STATE_3V3		3300
+#define IO_PWR_DOMAIN_OFFSET	0x800
+
+#define IO_PWR_DOMAIN_GPIO2_Kx	0x0c
+#define IO_PWR_DOMAIN_GPIO3_K1	0x10
+#define IO_PWR_DOMAIN_MMC_Kx	0x1c
+#define IO_PWR_DOMAIN_QSPI_K1	0x20
+
+#define IO_PWR_DOMAIN_V18EN	BIT(2)
+
+#define APBC_ASFAR		0x50
+#define APBC_ASSAR		0x54
+
+#define APBC_ASFAR_AKEY		0xbaba
+#define APBC_ASSAR_AKEY		0xeb10
+
+#define PIN_POWER_STATE_1V8	1800
+#define PIN_POWER_STATE_3V3	3300
 
 enum spacemit_pin_io_type {
 	IO_TYPE_NONE = 0,
@@ -61,12 +77,14 @@ struct spacemit_pinctrl_data {
 	int (*get_pins)(struct udevice *dev);
 	int (*get_functions)(struct udevice *dev);
 	int (*get_io_type)(struct udevice *dev, unsigned int pin);
+	unsigned int (*pin_to_io_pd_offset)(unsigned int pin);
 };
 
 struct spacemit_pinctrl_priv {
 	void __iomem		*regs;
 	struct spacemit_pin_io	*io_pins;
 	int			nr_io_pins;
+	struct regmap		*regmap;
 };
 
 struct spacemit_pin_mux_config {
@@ -197,6 +215,28 @@ static int k1_get_io_type(struct udevice *dev, unsigned int selector)
 	return -EINVAL;
 }
 
+static unsigned int spacemit_k1_pin_to_io_pd_offset(unsigned int pin)
+{
+	unsigned int offset = 0;
+
+	switch (pin) {
+	case 47 ... 52:
+		offset = IO_PWR_DOMAIN_GPIO3_K1;
+		break;
+	case 75 ... 80:
+		offset = IO_PWR_DOMAIN_GPIO2_Kx;
+		break;
+	case 98 ... 103:
+		offset = IO_PWR_DOMAIN_QSPI_K1;
+		break;
+	case 104 ... 109:
+		offset = IO_PWR_DOMAIN_MMC_Kx;
+		break;
+	}
+
+	return offset;
+}
+
 /* use IO high level output current as the table */
 static struct spacemit_pin_drv_strength spacemit_ds_1v8_tbl[4] = {
 	{ 0, 11 },
@@ -403,6 +443,35 @@ static const struct pinconf_param spacemit_pinconf_params[] = {
 	{ "power-source",	PIN_CONFIG_POWER_SOURCE,	U32_MAX },
 };
 
+static void spacemit_set_io_power_domain(struct udevice *dev,
+					 unsigned int pin,
+					 unsigned int io_type)
+{
+	struct spacemit_pinctrl_priv *priv = dev_get_priv(dev);
+	struct spacemit_pinctrl_data *data;
+	unsigned int offset;
+	u32 val = 0;
+
+	if (!priv->regmap)
+		return;
+
+	data = (struct spacemit_pinctrl_data *)dev_get_driver_data(dev);
+	if (!data || !data->pin_to_io_pd_offset)
+		return;
+
+	offset = data->pin_to_io_pd_offset(pin);
+	if (!offset)
+		return;
+
+	if (io_type == IO_TYPE_1V8)
+		val = IO_PWR_DOMAIN_V18EN;
+
+	regmap_write(priv->regmap, APBC_ASFAR, APBC_ASFAR_AKEY);
+	regmap_write(priv->regmap, APBC_ASSAR, APBC_ASSAR_AKEY);
+
+	writel(val, priv->regs + IO_PWR_DOMAIN_OFFSET + offset);
+}
+
 static int spacemit_pinconf_set(struct udevice *dev, unsigned int pin_selector,
 				unsigned int param, unsigned int argument)
 {
@@ -417,6 +486,7 @@ static int spacemit_pinconf_set(struct udevice *dev, unsigned int pin_selector,
 	data = (struct spacemit_pinctrl_data *)dev_get_driver_data(dev);
 	if (!data || !data->pin_to_reg)
 		return -EINVAL;
+
 	addr = data->pin_to_reg(dev, pin_selector);
 	switch (param) {
 	case PIN_CONFIG_BIAS_DISABLE:
@@ -459,10 +529,14 @@ static int spacemit_pinconf_set(struct udevice *dev, unsigned int pin_selector,
 			}
 			break;
 		}
-		if (!found && argument != PIN_POWER_STATE_1V8) {
+		if (!found && argument != PIN_POWER_STATE_1V8 &&
+		    argument != PIN_POWER_STATE_3V3) {
 			dev_err(dev, "Invalid power source (%d)\n", argument);
 			return -EINVAL;
 		}
+		if (found)
+			spacemit_set_io_power_domain(dev, pin_selector,
+						     priv->io_pins[i].io_type);
 		break;
 	default:
 		return -EOPNOTSUPP;
@@ -475,6 +549,7 @@ static int spacemit_pinctrl_probe(struct udevice *dev)
 	struct spacemit_pinctrl_data *data;
 	struct spacemit_pinctrl_priv *priv;
 	struct clk_bulk clks;
+	struct ofnode_phandle_args args;
 	size_t size;
 	int ret;
 
@@ -492,6 +567,19 @@ static int spacemit_pinctrl_probe(struct udevice *dev)
 		dev_err(dev, "Fail to allocate memory\n");
 		return -ENOMEM;
 	}
+	ret = dev_read_phandle_with_args(dev, "spacemit,apbc",
+					 NULL, 0, 0, &args);
+	if (ret) {
+		dev_warn(dev, "no APBC phandle found, disable IO power domain switching\n");
+		priv->regmap = NULL;
+	} else {
+		ret = regmap_init_mem(args.node, &priv->regmap);
+		if (ret) {
+			dev_warn(dev, "failed to get APBC regmap,"
+				 " disable IO power domain switching\n");
+			priv->regmap = NULL;
+		}
+	}
 
 	ret = clk_get_bulk(dev, &clks);
 	if (ret) {
@@ -519,6 +607,7 @@ static const struct spacemit_pinctrl_data k1_pinctrl_data = {
 	.get_pins	= k1_get_pins,
 	.get_functions	= k1_get_functions,
 	.get_io_type	= k1_get_io_type,
+	.pin_to_io_pd_offset = spacemit_k1_pin_to_io_pd_offset,
 };
 
 static const struct udevice_id spacemit_pinctrl_ids[] = {

-- 
2.51.0