[PATCH v5 5/8] soc: qcom: cmd-db: Allow boot without CMD DB data

In snagboot mode, XBL loads U-Boot directly without populating CMD DB.
The cmd-db driver fails to bind when CMD DB magic is invalid, blocking
boot even when CMD DB is not strictly required.

Use QCOM_SNAGBOOT_MODE config to allow the driver to bind
successfully when CMD DB data is absent. When QCOM_SNAGBOOT_MODE is
enabled and CMD DB data is present, we log a warning.

Signed-off-by: Balaji Selvanathan <[email protected]>
---
Changes in v5:
- Remove QCOM_COMMAND_DB_OPTIONAL definition from Kconfig as its now
  not used

Changes in v4:
- Removed QCOM_COMMAND_DB_OPTIONAL as now we use
  CONFIG_QCOM_SNAGBOOT_MODE
- Drop these warnings if snagboot mode is enabled since that's the
  expected case
- Log a warning if snagboot is enabled and we do have a valid cmd-db,
  since that isn't an expected usecase

 Changes in v3:
- Used "if (IS_ENABLED(CONFIG_QCOM_COMMAND_DB_OPTIONAL))" instead
  of #ifdef

Changes in v2:
- No changes
---
 drivers/soc/qcom/cmd-db.c | 15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)

diff --git a/drivers/soc/qcom/cmd-db.c b/drivers/soc/qcom/cmd-db.c
index d0a6047b8a6..c94a90a2903 100644
--- a/drivers/soc/qcom/cmd-db.c
+++ b/drivers/soc/qcom/cmd-db.c
@@ -252,8 +252,19 @@ static int cmd_db_bind(struct udevice *dev)
 
 	cmd_db_header = base;
 	if (!cmd_db_magic_matches(cmd_db_header)) {
-		log_err("%s: Invalid Command DB Magic\n", __func__);
-		return -EINVAL;
+		if (IS_ENABLED(CONFIG_QCOM_SNAGBOOT_MODE)) {
+			/* Missing CMD DB is expected in snagboot mode */
+			cmd_db_header = NULL;
+			return 0;
+		} else {
+			log_err("%s: Invalid Command DB Magic\n", __func__);
+			return -EINVAL;
+		}
+	}
+
+	if (IS_ENABLED(CONFIG_QCOM_SNAGBOOT_MODE)) {
+		log_warning("%s: CMD DB found in snagboot mode - this is unexpected\n",
+			    __func__);
 	}
 
 	return 0;

-- 
2.34.1